Hardware Accesories

Aluminium Heat Sink35mm x 35mm x 10mm..

Overview5-ch ITR20001/T infrared detector, high sensitivity, anti-jamming, stable performanceHigh precision analog output, combined with PID control algorithm, allows the robot tracks lines more stableSpecificationsPower: 3.3V ~ 5VDimension: 78mm × 18mmDetector spacing: 16mmMounting holes size: 3mmD..

This is a Gear Motor w/Encoder, model No.GB37Y3530-12V-251R. It is a powerful 12V motor with a 43.8:1 metal gearbox and an integrated quadrature encoder that provides a resolution of 16 counts per revolution of the motor shaft, which corresponds to 700 counts per revolution of the gearbox’..

This jaw type half-coupling can be used to connect a 6mm shaft to another shaft 10mm. It is held in place by two set screws, and fits together with another CL8-25 series jaw coupling of any shaft size with a hard elastomer spider in between.Jaw type couplings are ideal for high-torque applications a..

This jaw type half-coupling can be used to connect a 6mm shaft to another shaft 8mm. It is held in place by two set screws, and fits together with another CL8-25 series jaw coupling of any shaft size with a hard elastomer spider in between.Jaw type couplings are ideal for high-torque application..

This six-in-one power HUB is specially designed for FPV Quadcopter to simplify wiring. It comes with 6 functions : 1. Simplified power distribution wiring 2. 5V USB Port power supply 3. LED Flash light controller - three flash modes of LED lights can be chosen by switch 4. Lost Plane Finder -Mov..

Power Module is a simple way of providing your APM/Arduflyer with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6P cable The on-board switching regulator outputs 5.3V and a maximum of 3A from up to a 7S LiPo battery Special for APM2...

The POWER SWITCH is a tiny MCU controlled on/off switch for your radio controlled model. A simple push button operates the switch meaning to eliminate theproblems associated with intermittent contact of an ordinary mechanical switch.The sealed unit is plastic and can easily be mounted to the transpo..

The PPM Encoder plugs into the PWM servo output ports of any R/C  receiver and encodes them into a PPM pulse suitable for many autopilots  (e.g. Pixhawk). Modifications to the R/C receiver are not necessary.    The whole project is based around the ATMEL  Atmel168 AVR proc..