3DR Radio Telemetry Kit 915Mhz

Out Of Stock 3DR Radio Telemetry Kit 915Mhz

The 3DR Radio telemetry system is designed as an open source Xbee replacement radio set, offering a lower price, longer range and superior performance to Xbee radios. It's availabl in 915Mhz; and in the following configurations: serial board (for the air) and USB (for the ground).
- The radio is a 2-way half-duplex wireless communication system with a standard TTL UART interface, based on HopeRF's HM-TRP data link modules, and custom firmware that improves upon the modules' original features and performance.
- The SiK firmware includes a bootloader that permits radio firmware upgrades over the serial interface, and radio firmware with configurable parameters. Firmware upgrades and configuration are fully supported in the APM Mission Planner. Configuration is also possible through AT commands.
 
  

3DR Telemetry Kit Specifications 
 
- Very small size
- Light weight (under 4 grams without antenna)
- 915MHz
- Receiver sensitivity to -121 dBm
- Transmit power up to 20dBm (100mW)
- Transparent serial link
- Air data rates up to 250kbps
- MAVLink protocol framing and status reporting
- Frequency hopping spread spectrum (FHSS)
- Adaptive time division multiplexing (TDM)
- Support for LBT and AFA
- Configurable duty cycle
- Built in error correcting code (can correct up to 25% data bit errors)
- Demonstrated range of several kilometers with a small omni antenna
- Can be used with a bi-directional amplifier for even more range
- Open source firmware
- AT commands for radio configuration
- RT commands for remote radio configuration
- Adaptive flow control when used with APM
- Based on HM-TRP radio modules, with Si1000 8051 micro-controller and Si4432 radio module

Write a review

Please login or register to review
  • Views: 5057
  • Product Code: telemetry kit 915mhz
  • Availability: Out Of Stock
  • KES 4,500.00

Tags: telemetry kit

 This is a aluminum L shape connector bracket for servo. It's designed to attach a 'C' bracket ..
KES 200.00
This is our heat shrink kit. We use it for all sorts of handy projects. Use it to reinforce connecti..
KES 550.00
A 20cm, 40pcs wire cable connector from dupont. Male to Female terminated. ..
KES 100.00
Made from high-temp Nylon and gold plated spring connectors, The XT60 ensures a solid high-amp conne..
KES 80.00
These three-pin housings work with our wires with pre-crimped terminals to let you quickly make cust..
KES 50.00
W091022AUWORKPRO - a brand developed by GreatStar especially for home users and DIYers. In the last ..
KES 2,400.00 KES 2,000.00
Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition..
KES 3,000.00 KES 2,200.00
Specifications Model: MB-102 Dimension: 165mm x 55mm x 10mm Tie Points: 830 Tie Points con..
KES 200.00 KES 180.00
The DHT-22 is a low cost humidity and temperature sensor with a single wire digital interface. The s..
KES 900.00 KES 650.00
Need some indicators? We are big fans of these diffused red LEDs, in fact we use them exclusively in..
KES 100.00 KES 40.00
This is a pre-wired and waterproofed version of the DS18B20 sensor. Handy for when you need to measu..
KES 400.00 KES 300.00

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Name
Email
Phone
Comments