Logic Level Converter

Logic Level Converter

If you've ever tried to connect a 3.3V device to a 5V system, you know what a challenge it can be. This logic level converter is a small device that safely steps down 5V signals to 3.3V and steps up 3.3V to 5V. This level converter also works with 2.8V and 1.8V devices. Each level converter has the capability of converting 4 pins on the high side to 4 pins on the low side. Two inputs and two outputs are provided for each side.

Bread board friendly! Can be used with normal serial, I2C, SPI, and any other digital signal. Does not work with an analog signal.

The level converter is very easy to use. The board needs to be powered from the two voltages sources (high voltage and low voltage) that your system is using. High voltage (5V for example) to the 'HV' pin, low voltage (2.8V for example) to 'LV', and ground from the system to the 'GND' pin.

Pins are labeled as Inputs and Outputs. These are relative to the board. A digital one going into the RXI pin on the 5V side will show up on the RXO pin on the 3.3V side as 3.3V. A digital one going into the TXI pin on the 3.3V side will show up on the TXO pin on the 5V side as 5V.

 

Document:

Schematic

How to Use the Logic Level Converter

Write a review

Please login or register to review
  • Views: 2722
  • Product Code: Logic Level Converter
  • Availability: In Stock
  • KES 200.00
This board is based on a powerful 32bit CortexM3 ARM microcontroller made programmable through the f..
KES 4,000.00
The ESP8266 WiFi Module is a self contained SOC with integrated TCP/IP protocol stack that can give ..
KES 300.00
Say goodbye to unstable voltages with this LDO LD1117V33 linear regulator from STMicroelectronics. I..
KES 80.00
 Serial transceiver module is a low cost, high performance transparent FSK transceiver with ope..
KES 1,000.00
Specifications Model: MB-102 Dimension: 165mm x 55mm x 10mm Tie Points: 830 Tie Points con..
KES 200.00
This is a force sensitive resistor with a round, 0.5" diameter, sensing area. This FSR will vary its..
KES 1,500.00
Accurate sensor to measure AC/DC current up to 5A. The sensor can even measure high AC mains current..
KES 450.00
A 20cm, 40pcs wire cable connector from dupont. Male to Female terminated. ..
KES 100.00
Use this 3 mm IR Transmitter and Receiver pair to build object sensors, colour sensors, line se..
KES 50.00 KES 20.00
Atmel's ATMega328P 8-Bit Processor is in a 28 pin DIP package. It's like the ATmega168, with do..
KES 350.00 KES 300.00
Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition..
KES 3,000.00 KES 2,200.00
The DHT-22 is a low cost humidity and temperature sensor with a single wire digital interface. The s..
KES 900.00 KES 650.00
Need some indicators? We are big fans of these diffused red LEDs, in fact we use them exclusively in..
KES 100.00 KES 40.00
This is a pre-wired and waterproofed version of the DS18B20 sensor. Handy for when you need to measu..
KES 400.00 KES 300.00
OverviewSensitive to flame spectrumFeatures wide range voltage comparator LM393Adjustable sensitivit..
KES 200.00 KES 150.00

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Name
Email
Phone
Comments