Plastic Water Solenoid Valve - 12V - 1/2" (Minimum pressure requirement)

Out Of Stock Plastic Water Solenoid Valve - 12V - 1/2" (Minimum pressure requirement)

Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition to your robotic gardening project. There are two 1/2" (Nominal non-taped National Pipe) outlets. Normally, the valve is closed. When 12VDC is applied to the two terminals, the valve opens and water can push through. The valve has a gasket arrangement inside, so there is a minimum pressure requirement of 0.02 Mpa (3 PSI). Also, liquid can only flow one direction.


We tried this solenoid at various DC voltages and found we could actuate it down at 6VDC (although it was a little slower to open). Here is the current draw table for various voltages. We suggest a TIP120 or N-Channel power FET with a 1N4001 kickback diode to drive this from a microcontroller pin. For a power supply, our 9V 1A or 12V 1A power adapters will do the job.


If you want a beefier water valve, we also carry a brass version and plastic version which do not have a minimum pressure requirement and can be used with liquid flow in either direction.

 


Voltage Current

6V 160 mA

7V 190 mA

8V 220 mA

9V 240 mA

10V 270 mA

11V 300 mA

12V 320 mA

 



These solenoids are not rated for food safety or use with anything but water.

Write a review

Please login or register to review
  • Views: 3602
  • Product Code: Plastic Water Solenoid Valve - 12V - 1/2"
  • Availability: Out Of Stock
  • KES 1,000.00

Tags: Plastic Water Solenoid Valve - 12V - 1/2" (Minimum pressure requirement)

Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition..
KES 900.00
Model: PLIU-1077 Input: 100-240VAC 50/60Hz Output: 12VDC 2000mA Plug: EU Plug Adapter Size: (App..
KES 500.00
Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition..
KES 900.00
Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition..
KES 2,200.00
A high quality  AC to DC 9V 1000mA wall power supply. These will power most projects that do..
KES 250.00
Infrared proximity sensor made by Sharp. Part # GP2Y0A21YK has an analog output that varies from 3.1..
KES 1,000.00
The Arduino community has come up with the latest revision for the Uno board. It is a beautifully de..
KES 1,800.00
TIP120 NPN Power Darlington Transistor Manufacturer:ST Manufacturer Part No:TIP120 Package ..
KES 50.00
Manufacturer: GTK  RoHS: Yes       Specifications    ..
KES 10.00
These are 20cm and 10 cm long jumper wires terminated as male to male. Use these to jumper from any ..
KES 150.00
Model: 6LR61Size: 9vJacket: Aluminium Foil batteryCompliance: CE ROHSCapacity: 270ohm,24h/d,720minut..
KES 150.00 KES 120.00
Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition..
KES 3,000.00 KES 2,200.00
Specifications Model: MB-102 Dimension: 165mm x 55mm x 10mm Tie Points: 830 Tie Points con..
KES 200.00 KES 180.00
The DHT-22 is a low cost humidity and temperature sensor with a single wire digital interface. The s..
KES 900.00 KES 750.00
Need some indicators? We are big fans of these diffused red LEDs, in fact we use them exclusively in..
KES 100.00 KES 40.00
This is a pre-wired and waterproofed version of the DS18B20 sensor. Handy for when you need to measu..
KES 400.00 KES 300.00

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Name
Email
Phone
Comments