Arduino MKR WAN 1310
Click Image for Gallery
Connect your sensors and actuators over long distances harnessing the power of the LoRa® wireless protocol or throughout LoRaWAN™ networks.
The Arduino MKR WAN 1310 board provides a practical and cost effective solution to add LoRa® connectivity to projects requiring low power. This open source board can be connected to: Arduino Create, to your own LoRa® network using the Arduino Pro Gateway for LoRa®, to existing LoRaWAN™ infrastructure like The Things Network, or even to other boards using the direct connectivity mode.
The MKR WAN 1310, brings in a series of improvements when compared to its predecessor, the MKR WAN 1300. While still based on the Atmel SAMD21 low power processor, the Murata CMWX1ZZABZ LoRa® module, and the MKR family’s characteristic crypto chip (the ECC508), the MKR WAN 1310 includes a new battery charger, a 2MByte SPI Flash, and improved control of the board’s power consumption.
The latest low power architecture has considerably improved the battery life on the MKR WAN 1310. When properly configured, the power consumption is now as low as 104uA! It is also possible to use the USB port to supply power (5V) to the board; run the board with or without batteries - the choice is yours.
Data logging and other OTA (Over The Air) functions are now possible since the inclusion of the on board 2MByte Flash. This new exciting feature will let you transfer configuration files from the infrastructure onto the board, create your own scripting commands, or simply store data locally to send it whenever the connectivity is best. Whilst the MKR WAN 1310’s crypto chip adds further security by storing credentials & certificates in the embedded secure element.
These features make it the perfect IoT node and building block for low power wide area IoT devices. You can find here your board warranty information.
Microcontroller SAMD21 Cortex-M0+ 32bit low power ARM MCU (datasheet)
Radio module CMWX1ZZABZ (datasheet)
Board Power Supply (USB/VIN) 5V
Secure Element ATECC508 (datasheet)
Supported Batteries(*) rechargeable Li-Ion, or Li-Po
Circuit Operating Voltage 3.3V
Digital I/O Pins 8
PWM Pins 12 (0, 1, 2, 3, 4, 5, 6, 7, 8, 10, A3 - or 18 -, A4 -or 19)
Analog Input Pins 7 (ADC 8/10/12 bit)
Analog Output Pins 1 (DAC 10 bit)
External Interrupts 8 (0, 1, 4, 5, 6, 7, 8, A1 -or 16-, A2 - or 17)
DC Current per I/O Pin 7 mA
CPU Flash Memory 256 KB (internal)
QSPI Flash Memory 2MByte (external
SRAM 32 KB
Clock Speed 32.768 kHz (RTC), 48 MHz
USB Full-Speed USB Device and embedded Host
Antenna gain 2dB (bundled antenna at the Arduino Store)
Carrier frequency 433/868/915 MHz
Working region EU/US (confirmed) for other countries, please confirm the viability of using the radio spectrum.
Length 67.64 mm
Width 25 mm
Weight 32 gr.