DC Motor Speed Regulation Module PWM Regulator Controller Switch 20A Motor Driver

DC Motor Speed Regulation Module PWM Regulator Controller Switch 20A Motor Driver

Specifications:
Voltage: DC10-60V
Max Output Current: 20A(10A, less than 450W suggested if continuous use, enhance heat dissipation)
Max Power: 1200W
Speed Regulation Type: Current adjustment
Speed Regulation Mode: Potentiometer (linear)
Speed Regulation Duty Cycle Range: 0--100%
Control Frequency: 25KHZ
Wiring Methods: Barrier strip screw terminals
Knob Wire Length: 20cm / 7.87
Size: 7.6 x 4.4 x 2.7cm / 2.99 x 1.73 x 1.06"

 Note:

1. Make sure the positive and negative polarity is connected correctly.

2. Wiring should not touch heat sinks, or it will probably burn circuit board.This is not a power module. Only if the module is connected to motor first then it can control speed.

3. Please allow 1-3mm error due to manual measurement. 

Write a review

Please login or register to review
  • Views: 1261
  • Product Code: PWM DC Motor Speed Controller
  • Availability: In Stock
  • KES 600.00

Tags: DC Motor speed controller, motor driver

This is an LM2596S DC-DC buck converter step-down power module with high-precision potentiometer, ca..
KES 200.00
The analog gas sensor - MQ2 is used in gas leakage detecting equipments in consumer and industry mar..
KES 400.00
The following are the few advantages for NodeMCU that is based on ESP-12E and that is 2.4G wifi deve..
KES 800.00
This is a proximity ID card of 13.56Mhz ISO14443. It has been specially manufactured and packaged to..
KES 100.00
RC522 Chip: MF RC522 is applied to the highly integrated read and write 13.56MHz contactless comm..
KES 250.00
A 20cm, 40pcs wire cable connector from dupont. Provides a perfect DIP connection. ..
KES 100.00
W091022AUWORKPRO - a brand developed by GreatStar especially for home users and DIYers. In the last ..
KES 2,400.00 KES 2,000.00
Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition..
KES 3,000.00 KES 2,200.00
Specifications Model: MB-102 Dimension: 165mm x 55mm x 10mm Tie Points: 830 Tie Points con..
KES 200.00 KES 180.00
The DHT-22 is a low cost humidity and temperature sensor with a single wire digital interface. The s..
KES 900.00 KES 650.00
Need some indicators? We are big fans of these diffused red LEDs, in fact we use them exclusively in..
KES 100.00 KES 40.00
This is a pre-wired and waterproofed version of the DS18B20 sensor. Handy for when you need to measu..
KES 400.00 KES 300.00

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Name
Email
Phone
Comments