Search

5v 4-channel relay interface board. It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and so on.1-Channel Relay interface board, Each one needs 15-20mA Driver Current Equiped with high-current relay : DC30V 10A AC250V 10A Standard interface that ..

Product introduction:1. Operating voltage: 6--30V2. Trigger Signal Source: High Level Trigger (3.0 V-24 V), signal ground and system ground are not common, which can increase anti-interference abilitsystem (short circuit can also connect with a ground common)3. Output Capacity: can control no more t..

- This 6 DoF robot arm is designed from the ABB model by the similar principle. This joint of manipulator is connected by the good bearings, which can make the arm move with the smallest friction. So, it is the best choice for the teaching, function realization, and so on.- 6 degrees of freedom mani..

Jumper wires are simply wires that have connector pins at each end, allowing them to be used to connect two points to each other without soldering. Jumper wires are typically used with breadboards and other prototyping tools in order to make it easy to change a circuit as needed. Fairly si..

This version is the 5mm pitch 64x32 RGB LED Matrix. Please note you cannot use an Arduino UNO to drive this size, its way too big! Use an Arduino Mega, Raspberry Pi, BBB or other device that can handle displaying to RGB matricies and has plenty of RAM.This matrix has 2048 bright RGB LEDs arranged in..