Search

Specifications:Voltage: DC10-60VMax Output Current: 20A(10A, less than 450W suggested if continuous use, enhance heat dissipation)Max Power: 1200WSpeed Regulation Type: Current adjustmentSpeed Regulation Mode: Potentiometer (linear)Speed Regulation Duty Cycle Range: 0--100%Control Frequency: 25KHZWi..

This motor driver has a lot of great specs that make it useful for a wide variety of mechatronics. In particular, the simple resistor-set current limiting and auto-magic PWM support make it super easy to use with just about any brushed DC motor.Check out the specs for the DRV8871:6.5V to 45V motor p..

DescriptionLooking to play around with motors (stepper or DC)? This is the perfect chip. With two full H-bridges you can control either two DC motors or one bi-polar stepper motor (4, 5, 6, or 8 wire). Simply plug it into a breadboard and use the included one page guide to get your motors spinni..

The Device is a monolithic integrated high voltage, high current four channel driver designed to accept standard DTL or TTL logic levels and drive inductive loads (such as relays solenoids, DC and stepping motors) and switching power transistors.To simplify use as two bridges each pair of chann..

Double H driver module uses  L298N dual full-bridge driver, an integrated monolithic circuit in a 15- lead Multiwatt and PowerSO20 packages. It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoid..

A very compact dual channel H-bridge motor driver module. The module incorporates two L9110S H-bridge driver IC's to allow either one stepper or two DC motors to be independently controlled. The module can accept a supply voltage between 2.5 to 12V allowing for motors within this supply range to be ..

Manufacturer:     ON Semiconductor      Product Category:     Motor/Motion/Ignition Controllers & Drivers      RoHS:     No      Brand:     ON Semiconductor      Type: &nbs..

This is essentially a ramped up version of our Ardumoto motor driver shield. For this monster shield we've replaced the L298 H-bridge with a pair of VNH2SP30 full-bridge motor drivers. We've also beefed up the support circuitry so this board is capable of driving a pair of high-current motors! The V..

The SN754410NE from Texas Instruments is a quadruple half-H driver that can be used for bidirectional control of two DC motors or to control a single bipolar stepper motor. You can use this item as a replacement part, to stack on an existing motor controller, or to make your own motor or other high-..