ADXL 335 Triple Axis Accelerometer
Breakout board for the 3 axis ADXL335 from Analog Devices. The ADXL335 is a triple axis accelerometer with extremely low noise and power consumption - only 320uA! The sensor has a full sensing range of +/-3g.
There is no on-board regulation, provided power should be between 1.8 and 3.6VDC.
Connection
Here is the guide illustrates how to connect an Arduino to the ADXL335/345 breakout board. The following is a table describing which pins on the Arduino should be connected to the pins on the accelerometer:
| Arduino Pin | ADXL345 Pin |
| 0 | Z |
| 1 | Y |
| 2 | X |
| 3V3 | VCC |
| Gnd |
GND |
Documents
Tri-Axis Gyro L3G4200D
This is a breakout board for the L3G4200D low-power three-axis angular rate sensor. The L3G4200D has..
KES 400.00
MPU-6050 Accelerometer + Gyro
This board includes a MPU-6050 6-Axis Motion Processing Unit, a 2.5V voltage regulator, and the logi..
KES 400.00
Triple Axis Accelerometer Breakout - ADXL345
NTRODUCTION Breakout board for the Analog Device ADXL345. The ADXL345 is a small, thin, low power..
KES 500.00
MPU9250 9-DOF 3-Axis Accelerometer, Gyro, & Magnetometer
This MPU9250, which is a multi-chip module (MCM) consisting of two dies integrated into a single QFN..
KES 1,200.00
