Search

The soil sensor provides rapid access to Nitrogen (N) Phosphorus (P), Potassium (K), soil temperature, humidity, electrical conductivity (EC), and pH data, facilitating optimal irrigation timing and quantity for plants, thereby ensuring the best growing environment. It accommodates a wide voltage po..

The AM2302 is a wired version of the DHT22, in a large plastic body. It is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). It..

The AM2315 is a digital I2C humidity - temperature sensor that is mounted in a protective housing. It is not waterproof but sufficient to provide some protection to both sensors mounted inside. It use the DS18B20 along with a capacitive humidity sensor. It has it's own controller that provides a I2C..

The DHT11 Temperature and Humidity sensor module is designed to detect the surrounding environment for the humidity and temperature conditions. I t has a digital output signal that makes it easy to interface with the arduino. Specification:Humidity measurement range: 20%~90%RHHu..

This is a pre-wired and waterproofed version of the DS18B20 sensor. Handy for when you need to measure something far away, or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PVC so we suggest keeping it under 100°C. Because they are digital, you don't get any signal ..