Out Of Stock
NEO-M8N GPS / GNSS Module with EEPROM
KES 1,800.00
- Stock: Out Of Stock
- Model: GPS M8N Module
- SKU: 3514
This GPS / GNSS module is a more advanced version of our NEO-6M module. Compatible with UART capable devices including Arduino, Raspberry Pi, PIC, MSP430, and MSP432.
Power the module and it will automatically acquire satellite signals and a position fix. Once it has a position fix the module will blink the on board LED. This LED will continue to blink while the module has a position fix.
PRODUCT CONTENTS:
- 1 - NEO-M8N GY-GPSV3-NEO-M8N GPS / GNSS module with on board EEPROM
- 1 - GPS antenna
- 1 - 1x4 male header
SPECIFICATIONS:
- Input Supply Voltage Range: 3.3V-6V, on board voltage regulator maintains 3.3V
- I/O Maximum Logic Level: 3.6V
- To use with a 5V logic device, such as an Arduino, we suggest level shifting the 5V TX signal using one of the following: Two 1N4148 diodes in series between the TX pin on your 5V device and the RX pin on this GPS module (will drop voltage to ~3.6V,Only recommended for baud rates of 9600 and less ) or Use a logic level converter module such as the Bi-Directional Logic Level Converter
- 1 second to first fix (TTFF) for hot starts
- 26 seconds to first fix (TTFF) for cold starts
- On board LED will blink after module acquires a position fix and will continue blinking as long as the module has a fix
- 72-channel M8 engine GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1I, Galileo E1B/C, SBAS L1 C/A: WAAS, EGNOS, MSAS, GAGAN
- UART: 9600 baud by default, but is configurable from 4800 to 460800 baud
- 18Hz max update rate
- -157dBm Hotstart sensitivity
- Position Accuracy: 2 m and better with multiple good satellite signals
- Velocity Accuracy: 0.05 m/s
- Maximum Velocity: 500 m/s
- Heading Accuracy: 0.3 degrees while moving
- Power-optimized architecture with built-in autonomous power saving functions to minimize power consumption at any given time. Furthermore, the receiver can be used in two operating modes: Continuous mode for best performance or Power Save Mode for optimized power consumption respectively.
- Onboard EEPROM for configuration storage
- Onboard battery for battery backed RAM (BBR)
- Battery is recharged through a simple diode and resistor charger circuit from the on board voltage regulator's 3.3V output
- Four plated mounting holes, 3mm in diameter
- Weight: 17.6g (0.6oz)
- Dimensions of GPS Module: 36mm (1.42in) x 25.8mm (1.02in) x 4mm (0.16in)
- Dimensions of Antenna: 25.5mm (1in) x 25.5mm (1in) x 8.8mm (0.35in)
RESOURCES:
- Provided Resources:
- NEO-M8N Datasheet
- Receiver Description Including Protocol Specification
- test program for Windows (requires a USB to UART conversion module or dongle such as our CP2102 module)
- Arduino Library by Bolderflight (Can also be found via the Arduino library manager)
