All Products

5v 4-channel relay interface board. It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and so on.1-Channel Relay interface board, Each one needs 15-20mA Driver Current Equiped with high-current relay : DC30V 10A AC250V 10A Standard interface that ..

Connect this to that with an IDC cable! This cable has 6 pins (2x3) in 0.1"x0.1" spacing. Often used for programming AVRs. 6" long with two sockets crimped onto either side, they're quite sturdy!..

Product introduction:1. Operating voltage: 6--30V2. Trigger Signal Source: High Level Trigger (3.0 V-24 V), signal ground and system ground are not common, which can increase anti-interference abilitsystem (short circuit can also connect with a ground common)3. Output Capacity: can control no more t..

- This 6 DoF robot arm is designed from the ABB model by the similar principle. This joint of manipulator is connected by the good bearings, which can make the arm move with the smallest friction. So, it is the best choice for the teaching, function realization, and so on.- 6 degrees of freedom mani..

This version is the 5mm pitch 64x32 RGB LED Matrix. Please note you cannot use an Arduino UNO to drive this size, its way too big! Use an Arduino Mega, Raspberry Pi, BBB or other device that can handle displaying to RGB matricies and has plenty of RAM.This matrix has 2048 bright RGB LEDs arranged in..

You can now attack just about every kind of box or enclosure that needs undoing with this ratchet screwdriver set. This set is fine quality and excels at disassembling and assembling larger hardware.What drew us to this tool box is its comprehensive selection of bits, the two rubber screwdriver ..